DUMP TRAILER Power UNIT-DOUBLE ACTING
This energy unit has a power up electrical power down circuit with load holding on each A & B ports. A pressure compensatred movement management can be extra to circuit to control the decent velocity of your cylinder.
1. This power unit is of S3 duty cycle, i.e., non-continuous operation, 30 seconds on and 270 seconds off.
2. Clean all of the hydraulic parts concerned before set up of the electrical power unit.
three. Viscosity of your hydraulic oil shoud be 15~46 cst, which should really also be clean and totally free of impurities. N46 hydraulic oil is encouraged.
four. The electrical power unit should be mounted horizontally.
five. Check the oil degree during the tank following the first working of your energy unit.
6. Oil modifying is required right after the preliminary 100 operation hours, afterwards as soon as every single 3000 hours.
DUMP TRAILER Power UNIT- SINGLE ACTING
This energy unit features a power up gravity down circuit. Start out the motor to extend the cylinder and activate the solenoid valve to retract the circuit. Guide override to solenoid valve might be supplied if needed. Also a strain compen sated flow manage might be extra towards the circuit to regulate the descent speed of your cylinder.
Remark: Please seek advice from our income engineer for that distinct pump displacement, motor power or tank capacity.
1. This electrical power unit is of S3 duty cycle, i.e., non-continuous operation, 30 seconds on and 270 seconds off.
2. Clean all of the hydraulic parts concerned ahead of installation of the energy unit.
three. Viscosity with the hydraulic oil shoud be 15~46 cst,which really should also be clean and no cost of impurities.N46 hydraulic oil is suggested.
four. The electrical power unit really should be mounted horizontally.
five. Check the oil level within the tank just after the original operating of your power unit.
6. Oil transforming is needed immediately after the original a hundred operation hrs, afterwards as soon as each 3000 hrs.