ep

January 20, 2021

Electrical power UNITS FOR LIFT TABLE 1
Common Description
This power unit is designed solely for that tiny lift table,Consisting of large strain gear pump, AC motor, multi-functional manifold, valves, tank, and so on. This electrical power unit continues to be broadly used inside the industry of logistic devices which include minifork lift, scissors lift and ariel operating platforms. The lower-ing movement is managed from the solenoid valve with all the velocity managed through the adjustable needle valve.
Power UNITS FOR LIFT TABLE 2
Basic Description
This energy unit is intended exclusively for that medium lift table, Consisting of very effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The decreasing movement is actived from the solenoid valve as well as speed managed from the adjustable needle valve. When the lift rises to a higher positoin, but the energy supply is cut, the lowering motion is controlled through the manual override function.
Energy UNITS FOR LIFT TABLE 3
Basic Description
This power unit is built solely for your big lift table, Consisting of hugely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing movement is actived from the solenoid valve plus the pace controlled by a pressure compensated movement manage valve.
Electrical power UNITS FOR LIFT TABLE 4
Common Description
This power unit is created exclusively for the substantial lift table, Consisting of very effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing movement is actived from the solenoid valve along with the speed controlled through the adjustable needle valve. When the lift rises to a substantial positoin, but the power supply is lower, the decreasing motion is controlled by the manual override perform.
Special Notes
1. This electrical power unit is of S3 duty cycle, which can only work intermittently and repeatedly, i.e. one minute on and 9 minutes off.
two. Clean every one of the hydraulic parts concerned ahead of set up of the energy unit.
3. Viscosity in the oil shoud be 15~46 cst,which should also be clean and totally free of impurities.N46 hydraulic oil is suggested.
four. Oil shifting is needed soon after the initial one hundred operation hours,afterwards the moment each and every 3000 hrs.
five. The energy unit proven is built to be mounted vertically.