ep

January 4, 2021

1.A connecting link of an O-ring Chain for basic application is pre-coated with grease at the pins. Before connection, confirm the grease around the surfaces of pins, and when the amount of grease is modest, apply grease with bare hands. (If gloves are utilized, the grease might be absorbed through the gloves.)
Instance: When the connecting hyperlink (I) of an O-ring chain for common application is
shipped, O-rings are fitted at the roots in the pins. In case the O-rings come loose because of vibration throughout transport, refit the O-rings in to the roots of the pins.
In this instance, you’ll want to return the grease collected at the roots on the pins to your central surfaces on the pins, extra at portion A than at portions B shown while in the above illustration. (Portions A is worn due to sliding with the bushings.)
two.The chain could be most conveniently linked to the teeth of the sprocket. Engage the back links at both ends in the chain using the sprocket teeth and match connecting pins. Should the sprocket can be moved, the chain can also be connected to the loosened side.
three. Connecting process
one.Confirm that O-rings are attached to the roots on the pins.
two.In case the level of grease utilized within the connecting pins is little, coat the pins with grease in the central portions.
three.Insert the connecting pins in to the bushings from the inner hyperlinks at each ends.
four.Confirm the grease is applied to the total encounter in the O-ring, and match the O-ring onto the connecting pins.
five.Insert the connecting pins in to the connecting plate and when pressing the connecting plate, set up the spring clip. Verify no matter whether the head (the end without a split) on the spring clip is turned in the feeding path on the chain. (See the following illustration.)
six.Make sure to confirm the spring clip is securely fitted while in the clip grooves on the connecting pins.
This completes jointing in the connecting website link. Note that grease to the surfaces of connecting pins and O-rings may be eliminated during installation work. In this case, re-grease making use of the grease to the surface of the base chain or the grease inside the polyethylene bag during which the connecting hyperlink was contained.