Every product has two kinds of procedures. It is necessary to disassemble and assemble. If you don't use these two to make a product with many processes, it will basically be useless, so you can see that the product does not have these two. No, the following hydraulic cylinder manufacturers will talk about how to disassemble and assemble hydraulic cylinders correctly and effectively.
1.Before disassembling the hydraulic cylinder, the hydraulic circuit should be relieved of pressure, otherwise, when the oil pipe connected with the cylinder is loosened, the high-pressure oil in the circuit will be sprayed out quickly.
2.When disassembling, prevent damage to the thread on the top of the piston rod, the thread of the oil port, the surface of the piston rod, and the inner wall of the cylinder liner.In order to prevent the slender parts such as the piston rod from bending or deforming, the stow should be used to support the balance.
3.The disassembly must be carried out in order, because the structure and size of various hydraulic cylinders are not the same, the disassembly sequence is also slightly different. 4.Before and after disassembly, try to create conditions to prevent the parts of the hydraulic cylinder from being contaminated by surrounding dust and impurities.
5.After the oil cylinder is disassembled, check carefully to determine which parts can continue to be used, which parts can be used after repair, and which parts must be replaced.
6. A special wrench should be used when tightening the threaded connection, and the torque should conform to the standard and meet the standard requirements.
7.When the hydraulic cylinder is installed on the main engine, the oil inlet and outlet joints must be fitted with sealing rings and fastened to prevent oil leakage.
8. After the assembly is completed, there should be no blockage and uneven resistance when the piston assembly moves.
9.After the piston and the piston rod are assembled, try to measure whether their coaxiality and straightness over the full length are out of tolerance.
In this way, there is no error in the product. There will be no problems in the process of use. Only the correct method will not cause problems, so no matter what kind of product worm gear reducer,The worm gear box must have a good understanding in installation and disassembly.
