If you want the equipment to produce products without any problems, it is necessary to conduct a good inspection before using the equipment, which is very important for both the equipment and the product.At the same time, adjustment and operation of Worm gearbox and other equipment are also very important. Therefore, now the band sawing machine accessory manufacturer will talk with you about the adjustment and operation of the vertical sawing machine.
XNUMX. Machine tool adjustment: After the machine tool is installed, the machine tool should be adjusted before cutting. The content is as follows:1, Prepare the corresponding band saw blade according to the length of the saw band required by the technical parameters, and the tooth type of the saw band should be selected according to the shape and material of the material.2, Put the prepared band saw blade on the two saw wheels and snap it into the guide wheel and the center of the guide, and then tighten the saw band.3, Check whether the three-phase power supply is in good contact, and whether the running direction of the water pump, band saw, and motor is correct.
XNUMX. Operation of the machine tool: After the adjustment and preparation work before cutting is completed, you can operate the machine tool for normal cutting according to the following procedure: Lift the workpiece on the worktable and the rack, make the workpiece parallel to the worktable, and then move the Transport to the position where it is in contact with the plane of the sizing device.
Only by doing this can we be safe in the process of using, and can also make the product safe in the process of production and processing, so we must do a good job for the equipment to be done.
