Worm gear reducers generally use 220# gear oil. For reducers with heavy loads, frequent starts, and poor use environments, the factory also uses some lubricating oil additives (such as Anji Chemical Company’s good). When the operation is stopped, the gear oil is still attached to the surface of the gear to form a protective film to prevent heavy load, low speed, high torque, and metal-to-metal contact during startup.The additives also contain seal ring regulator and anti-leakage agent to keep the seal ring soft and elastic and effectively reduce lubricating oil leakage.
Selection of the installation location of the reducer
Where the location permits, try not to use vertical installation.In vertical installation, the amount of lubricant added is much larger than that in horizontal installation, which is likely to cause heat generation and oil leakage of the reducer.Some of the 40000 bottles/hour pure draft beer production lines introduced by the factory are installed vertically. After a period of operation, the transmission pinion gears are greatly worn or even damaged. After adjustments, the situation has been greatly improved. .
