The problems in the production of band sawing machines are related to band sawing machine accessories

The problems in the production of band sawing machines are related to band sawing machine accessories. Everyone should know this! It is also very common in our lives! Because this kind of equipment has very good effects, work efficiency can also be greatly improved ! But I don’t know if you know how many aspects of the relationship should be understood? Let’s take a look!

   What problems will occur when the band sawing machine is produced? The wear of the guide block causes the wear of the saw back, which leads to cracks on the back of the horizontal band saw band, which causes the belt to break.The guide block alloy has obvious wear marks and grooves, and the saw blade has irregular scratches and cracks at the scratches, which should be checked frequently.
The gap of the upper guide block is not appropriate, the back of the saw is pressed too much, the tension at the root of the saw tooth is too large, cracks are generated, and the belt is broken.View method: Adjust the cutting point of the two wheels so that the two saw arms are sewn on the same horizontal line.The saw back and shoulders must be spaced apart at a certain interval so that the paper does not have to be blocked.The saw blade is worn out due to over-tightening or over-looseness, causing the side of the saw band to be scratched.

The load of the band saw machine is too tight to break; if it is too loose, the saw band may deflect or the cut may be corrugated.The saw speed and deceleration are not well matched, the saw speed is low, the speed is reduced, the saw belt load is too large, and the belt breaks.The saw speed is fast, the speed is slow, the work efficiency is low, and the tooth tip is prone to early wear and tear, which affects the service life.

Generally, you can learn from these aspects!If you need Band saw accessorie, worm gear box reducer, worm gear box and other products, you can contact us for consultation. You are welcome to call.